New to forum.

[V8genie]

Hi all. Just bought my first 4.2 S type and loving it. 2004 pre sat nav model. A question though. I need to programme a new  original Jaguar remote fob. Checked all the YT vids but none work.

Could go to my local jag man but I am assured this can be done without that unwelcome cost. Anyone had any luck.

Thanks in advance. 

[Guest]

Hi Mark and Welcome to the Club,

I found the following which was posted some time ago by another member. I have not had to use this advice myself but others have and seemingly with success. Hope this helps with your problems. Let us all know how you get on.

Cheers,

Steve

S-Type Remote Control Programming (Procedure 1)

2.) Ensure Drivers door & boot is open.
3.) Hold high beam switch towards you.
4.) Insert key in ignition and turn to accessory position .
5.) Release high beam switch.
6.) Pull & release high beam switch 4 times slowly.
7.) Listen for chime.
8.) Press lock button on each remote to be programmed.
9.) Listen for chime.
10.) Ignition off.
11.) Close & open door.
12.) Test remotes.
 

S-Type Remote Control Programming (Procedure 2)

2.) Turn ignition from O to II four times.
3.) A chime will be heard.
4.) Press the button on each remote that requires programming.
5.) Switch ignition OFF.
6.) Test each remote control.
 

S-Type Remote Control Programming (Procedure 3) (UK Variant)

2.) Get in the car and close the drivers side door.
3.) Put the key into the ignition and turn to position 0.
4.) Wait 5 seconds.
5.) Turn the key quickly to position II then back to 0 four times.
within 6 seconds (do this only once)
6.) You should hear a single chime.
7.) Remove the Key.
8.) For each Key fob in rapid succession. Press and hold the Boot (Trunk) release, lock or unlock button on the key fob you wish to pair, you should hear a chime as each Key fob is paired with the security system. After the chime repeat the process on the next Key fob you wish to pair.
9.) On compleation after all keys have been programed, wait 3 minutes then check the operation of each Key fob by locking/unlocking the vehicle.

Important Note :-All the fobs that you wish to use Must be paired at the same time. Every time you operate the key as in step 5 above the code will be changed, previously programmed fobs will no longer work unless you pair them all at the same time.