glow plug relay location X260 (XF)

[chippy17]

HI All,

Still having issues with the glow plugs on my 2016 XF 2.0D.

Have removed all 4 of the glow plugs and tested them on a 12v supply all are working, but the engine still miss fires for a few seconds when really cold.

I suspect that the glow plug relay might be suspect, only problem is i cant fid it!! can anyone help with the location?

thanks

John.

[chippy17]

Hi All

Have found glow plug relay now!

Sited O/S chasis rail behind radiator.

oblong unit about 3 inches long, aluminium heat sink with two large conectors.

[James T]

On 12/5/2019 at 8:42 PM, chippy17 said:

Hi All

Have found glow plug relay now!

Sited O/S chasis rail behind radiator.

oblong unit about 3 inches long, aluminium heat sink with two large conectors.

Did you sort your problem?

[AussieScot]

Good morning. 

 

I'm having the same issue's with my 2016 3.0d, got the code for the glow plug heater relay, can anyone direct me to where it's located.

[StuMac]

HI AussieScot, did you locate the relay? My x260 also 2016 3.0D started taking a bit longer to start last couple of weeks. Have received and cleared the error code 'P052F' (Glow plug control module - voltage malfunction) a couple of times. If any1 can spare me some time with the location and part number that would be appreciated!

[StuMac]

Found this. Its from the X260 workshop manual this is for the 3v6D. Although I had a quick look and cant see it, will need to look when i have more time.

[Thorleif Lager]

If you, as me have a X260 TVD6_3L, the glow plug controls are as shown on this picture (from the Workshop manual).

 

[StuMac]

Thanks Thorleif, looks similar relative location as the image I posted. Had another look and pretty sure I have located it. The image I posted is correct, but its directly under the drivers side air box/filter, you can see the edge of it under the airbox and between the airbox and driver's side front wing. From underneath it sits between the right side radiator and the wheel arch liner you can see it through the front slots in the wheel arch liner or from under as seen below in the second picture.

 

Seems a bit of a stupid place to put this, given how small it is and how much space available in the engine bay.

 

So to access & replace its either - Remove the right/drivers side air box/filter housing or Remove the wheel and wheel arch liner.

 

Pics below top down, its 

[StuMac]

In case it helps any1 else. in an x260 3v6D The Glow plug control module sits under the right side airbox housing. The picture below shows the module after removing the airbox. That pipe makes it unlikely for the module to be removed up through the engine bay, i tried but just not enough wiggle room. I think its best to remove the airbox, unscrew the module, unplug the cables and drop it to the ground at the wheel arch liner. Then reverse to fit now module.

[Leemumby]

I've got the same issue with my XF X260 3.0, does anyone the part number of the part I need to order or a aftermarket part I can get. Thanks 

[Davidse]

Hi there did someone find the location of the glow plug relay on a Jaguar xf 30.d 2017 (X260)? I looked everywhere and didn't find it . 

[Davidse]

I found the exact locationof the glow plug relay on my Jaguar Xf 3.0 D 2017 (X260) . It was under the Airfilter ,you just have to take that one out and there you will find it .

[John 78]

Hi, does anyone have a part number for the glow plug module on the 3.0d (2018). Thank you. 

[Felipe86]

For those of you needing the part number, I've just taken mine off to replace. Replacement was 60 bucks off eBay. 

2017 Jaguar XF-S 3.0d