Jaguar Xe fault code P25A9-00. Piston oil jets cooling solenoid

[johan3134]

On 9/10/2020 at 7:23 PM, Ian72 said:

Hi All

i am after some advise I have the above code come up on my car and even though I have took 5 independent garages and no ones seems to have a clue what is causing the issue. After googling the web I replaced the cam shaft sensor as it was an easy fix to try and do myself, but didn’t resolve the issue. 
After all this decided to take to to Jaguar itself and they advised it was 100% the camshaft sensor until I mentioned I have replaced this and then they mentioned it must be the wiring which they also checked and was ok. Now they seem to think it is due to the timing belt being stressed. I am not sure this is the fault but an expensive check if it isn’t. 
has anyone had the fault Before or have any idea what is causing this as the engine management light is on. The only difference I have noticed is that when you press the start stop button is takes about 6 revolutions to turn over. 

Many thanks for any advise? 
Ian
 

 

 

Dear

This is a Oil jet faulty. I had same i replace it its around 140 euro. The problem is to replace it. Its not an easy job to reach this solenoid but if you have a bit idea about engine you can replace it. I remove water coolant tank, water pipes where is thermostat and the solenoid is behind it. Good luck 🤞