Jump to content


Recommended Posts

Posted

Rear camera worked when I reversed on drive , when I started to drive to work the next morning,  it came up on dash as a fault that the camera had stopped working , sure enough when I reversed into parking spot it had stopped , censors still working,  any clues or is there a way off testing to see what is the fault,  weid this is the 3rd xf I've had all seem to get the same faults aircon and rear camera! Worse is it's just out of warranty,  bugger.

Posted

Think I have read that it is normally a wiring fault. Hopefully someone more knowledgeable will be along soon.

Posted
On 5/12/2021 at 6:19 AM, Bigvic said:

Duff boot harness at the hinge point

I’ve just had lots of problems with this harness, luckily my camera kept working. Get it checked as it is apparently a weak point.

Posted

Hi Tony and others

I went through the same problems over a year ago but occasionally it would work. In my case the camera worked, but I lost the yellow guide lines so I have had an aggravated year during Lockdown using only 1 tank of deisel since last October, so I just lived with the problem. However a couple of weeks ago my passenger side back door would not open from the outside, this I thought could be dangerous so I booked my car in on Tuesday 18th to my new favourite garage in Storrington West Sussex. It cost me £96.01 for the Boot Wiring Loom, the Nearside rear Door locking motor £134.38 4 hours labour £240.00 Sub total £470.39 with VAT £564.47. I am now happy again although a little poorer. Happy to share more detailed information if anone needs it. I have been told that the Door locking motors are very unreliable and some XF drivers have had to replace three motors on their cars.


  • 2 years later...
Posted
On 5/12/2021 at 3:19 PM, Bigvic said:

Duff boot harness at the hinge point

OK, so I replaced that with genuine Jag part… still getting the cameras not available ….’  message.. Where to now?


Posted

Hi

Parking sensors and camera work together as a unit so if any part is faulty the whole system is shut down.

This means if a single front bumper sensor does not work the whole system shuts down. You need to get the fault codes read as this will help locate the problem.

When it happened to me the fault code showed the front offside sensor had failed. However fault was still present after this was replaced as the front bumper wiring loom was at fault and the code thrown will be for the failure of the component served by the faulty wiring. New front bumper wiring loom and the reversing camera came back to life 🙂.

So get the codes read before doing anything else.

John

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...





×
×
  • Create New...



Forums


News


Membership


  • Insurance
  • Support