Torque setting

[Omen]

Is there a torque setting and if so what is it please ?

For the rear anti-roll bar drop links. 

[Jimbov8]

If memory serves, 42Nm.

[Omen]

Thanks Jim. Just got to figure out how to torque the four nuts with a spanner. Only have a torque wrench that is used with sockets. I guess you know it is not possible to use sockets, without turning the pin at the same time. 
needs some thought. . . . 

[Jimbov8]

44 minutes ago, Omen said:

Thanks Jim. Just got to figure out how to torque the four nuts with a spanner. Only have a torque wrench that is used with sockets. I guess you know it is not possible to use sockets, without turning the pin at the same time. 
needs some thought. . . . 

The force required is equivalent to a third of that for a wheel nut. So to give you an idea, loosen a wheel nut and tighten it to 42Nm to give you an idea of how much force you need to exert on the spanner.

Don't forget to retighten the wheel nut.

[Omen]

Crackin idea, thanks will do that tomorrow. Hopefully it will have stopped raining then.