Jump to content


Leaderboard

Popular Content

Showing content with the highest reputation on 12/28/2015 in all areas

  1. hi I bought some of these ages ago i used 4 off these to make a 4 wheel alignment gauge for my mitsubishi they might do the job and for the price you wont lose much anyway they work off 2 AAA batteries but you could easily replace them with a power supply have added some pics 2 off ebay cheers Joe
    1 point
  2. Welcome Tim from another new member, I've had mine for just over a week. [emoji1]
    1 point
  3. Welcome to the club, Tim. It is a friendly club with helpful members. You will enjoy the S type -- a great car to drove whether fast or sedate. Regards, Peter,
    1 point
  4. Hi Tim The first cut is the scary one (no going back!) if you are getting your mesh from Adamesh, I would advise ignore the instructions that suggest using a Jigsaw! The plastic is way to soft / flimsy and would be quite easy to cut in half, much better to use the hacksaw. The lower mesh, behind the plate, is a bit of a Faff, you will get some aluminium blocks to use, to anchor the mesh to the existing grill, again I would advise thread the blocks first with the screws provided, rather than trying to do it while holding the mesh / blocks and a screw driver all at the same time. the screws provided, have very small heads, and will actually pass through the mesh, when you have decided where to place them, use pin nose pliers to squeeze the mesh around the head, or use some very small washers If you can post some pics, and keep us up to date Regards Steve
    1 point
×
×
  • Create New...



Forums


News


Membership


  • Insurance
  • Support