Jump to content


Leaderboard

Popular Content

Showing content with the highest reputation on 05/09/2024 in all areas

  1. We’ll triumph, Dave lol. Keep me posted on how you get along with everything. The suspension job sounds like a big undertaking, and not one I would relish. Next for me is broken glow plug removal and then full service. I’m praying the heater core doesn’t need to come out. Speak soon, mate. All the best, and give me shout if you need anything. Take care.
    1 point
  2. Hi, Dave Hope you’re keeping well (never sure whether to “quote” or just reply to the topic lol). I completely blanked it off at the throttle body and where the pipe meets the — cooler(?), and removed the two pipes completely. So, four plates in total for the S Type (X2004). Not sure if the X Type is the same. I got no light or anything, and I didn’t remove the throttle body butterfly, because I wasn’t sure how, even though others advise to do so. Not sure if this makes a difference or not. I did some research on my model and discovered that deleting the EGR from the ECU isn’t necessary. However, if the garage is going to sort all that out for you, then let them get on with it. Maybe they’ll discover it’s unnecessary. I dunno. I’d have to research the X Type to know. Not sure if it was related, but I got an “unusal flow” (or something like that) alert recently. I removed the throttle body, checked the butterfly actuator, tightened the blanking plates, refitted everything, and now everything is fine again. unrelated to the EGR, but as an aside, I recently replaced the glow plugs (bit of a nightmare job) and the last one snapped off. So now I have to figure out how to remove that. Oh, joy. Incidentally, it seemed that the ones on the left bank(?) - passenger side - were all seized and dirty. Not sure if this is a sign something is wrong. I’m still getting coolant loss, particularly when I ride her hard. Mechanic found nothing after pressure test, and I did a block test and got a negative result for gasket failure. I suspect the heater core needs to be removed. I also recently replaced the transmission fluid and filter and reset the TCM/TCU — doing that on your back is a bar-steward lol. keep me up to speed on everything, please, Dave. I’m interested to know how everything goes, and would like to help, if I can. All the breast Marty 😉
    1 point
×
×
  • Create New...



Forums


News


Membership


  • Insurance
  • Support